Share :


The addition of the new Century Pump to the Binks LEL, or “Low Emission Laminator” technology provides a complete selection of FRP spray guns, spray tips, air nozzles and mixing valves for the non-atomizing application of resins and gel coats used in open molding processes.

Enquiry Request

Pressure Ratio6.5:117:1
Flow Rate at 60 cycles per minute2.0 GPM (7.6 L/min)
Supports1 Century Spray Gun–“62” LEL tip or .036″ AA tip
Displacement per cycle4.26 oz (126 cm³)
Inlet Fluid Connection1″ NPT (f) or 1¼” NPT (m)
Outlet Fluid Connection1/2″ NPT (f)
Air Connection3/8″ NPT (f)
Wetted Materials Resin PumpAnodized Aluminum, Plated Carbon Steel, Stainless Steel, Hard Chrome, Nylon, PTFE, UHMWPE, Tungsten Carbide
Wetted Materials Catalyst PumpStainless Steel, Silicone Rubber, PTFE, UHMWPE
Max Fluid Pressure with included air motor750 psi (52 bar)1970 psi (136 bar)
Max Air Inlet Pressure116 psi (8 bar)
Max Recommended Cycle RateUp to 40 Cycles/minute—not continuous
Noise Level96 dB(A)97 dB(A)
FRP Spray Gun Selection Guide